Axle Breakage in Reducer Output?
Common Installation Problems of Reducer --Shaft Broken Problem of Reducer with Too Small Output,In addition to the axle breakage caused by poor concentricity of the output assembly of the reducer, if the output axle of the reducer is broken, there are no more than the following reasons. First of all, the incorrect selection results in insufficient output of the gearbox. Some users mistakenly believe that as long as the rated output torque of the selected reducer meets the working requirements, in fact, otherwise, the first is that the rated output torque of the distribution motor multiplied by the deceleration ratio, and the value obtained is in principle smaller than the rated output torque of the similar reducer provided by the product sample, and the second is that the overload capacity of the drive motor and the most needed in practice should also be considered. Large working torque. In theory, the maximum working torque required by the user. Must be less than 2 times the rat