Axle Breakage in Reducer Output？
Common Installation Problems of Reducer--Shaft Broken Problem of Reducer with Too Small Output，In addition to the axle breakage caused by poor concentricity of the output assembly of the reducer, if the output axle of the reducer is broken, there are no more than the following reasons.
First of all, the incorrect selection results in insufficient output of the gearbox. Some users mistakenly believe that as long as the rated output torque of the selected reducer meets the working requirements, in fact, otherwise, the first is that the rated output torque of the distribution motor multiplied by the deceleration ratio, and the value obtained is in principle smaller than the rated output torque of the similar reducer provided by the product sample, and the second is that the overload capacity of the drive motor and the most needed in practice should also be considered. Large working torque. In theory, the maximum working torque required by the user. Must be less than 2 times the rated output torque of the reducer.
Especially in some applications, this criterion must be strictly observed. This is not only the protection of the reducer, but also the main thing is to avoid the output shaft of the reducer being twisted. This is mainly because if there is a problem in the installation of the equipment, the output shaft and its load of the reducer are stuck. At this time, the overload capacity of the driving motor will continue to increase its output force, and then, the output bearing of the reducer may be subjected to more than twice its rated output torque and the output shaft of the reducer will be broken.
Secondly, in the process of acceleration and deceleration, if the instantaneous torque of the reducer output shaft is more than twice its rated output torque, and the acceleration and deceleration are too frequent, the reducer output shaft will eventually be broken. Considering that this situation occurs less frequently, we will not introduce it further here.
Portal:https://www.zwgearbox.com/
First of all, the incorrect selection results in insufficient output of the gearbox. Some users mistakenly believe that as long as the rated output torque of the selected reducer meets the working requirements, in fact, otherwise, the first is that the rated output torque of the distribution motor multiplied by the deceleration ratio, and the value obtained is in principle smaller than the rated output torque of the similar reducer provided by the product sample, and the second is that the overload capacity of the drive motor and the most needed in practice should also be considered. Large working torque. In theory, the maximum working torque required by the user. Must be less than 2 times the rated output torque of the reducer.
Especially in some applications, this criterion must be strictly observed. This is not only the protection of the reducer, but also the main thing is to avoid the output shaft of the reducer being twisted. This is mainly because if there is a problem in the installation of the equipment, the output shaft and its load of the reducer are stuck. At this time, the overload capacity of the driving motor will continue to increase its output force, and then, the output bearing of the reducer may be subjected to more than twice its rated output torque and the output shaft of the reducer will be broken.
Secondly, in the process of acceleration and deceleration, if the instantaneous torque of the reducer output shaft is more than twice its rated output torque, and the acceleration and deceleration are too frequent, the reducer output shaft will eventually be broken. Considering that this situation occurs less frequently, we will not introduce it further here.
Portal:https://www.zwgearbox.com/
评论
发表评论