Differences in Design and Selection Methods of Universal Reducer and Special Reducer

The biggest difference between the general reducer and the special reducer is that the former is suitable for all industries, but the deceleration can only be designed according to a specific working condition. Therefore, when selecting the reducer, users need to consider different correction coefficients according to their requirements. The factory should select the motor power according to the actual selection (not the amount of the reducer). The latter is designed according to the user's special conditions, and the coefficients considered in the design are generally considered. The method is relatively simple as long as the power used is less than or equal to the rated power of the reducer.

The general reducer often has to limit the maximum radial load allowed on the middle part of the extension of the input shaft and the output shaft. It should be checked. When exceeding the limit, the requirement of increasing the diameter of the shaft and the bearing should be put forward to the manufacturer.

Portal：https://www.zwgearbox.com/